31
EN
Welding technology aspects
Shielding gases
for Drive Ea
-
syTwin
Gas flow for Drive
EasyTwin
-
Total gas flow rate at least 30 l/min
NOTE!
Due to the reduced setting options (synchronisation), we recommend shielding gas
-
es with a low active proportion of shielding gas, e.
g. 96% argon/4% oxygen or 90% argon/10% CO2. This results in less spattering and, in
turn, considerably less wear.
Earth connection
Use a separate grounding (earthing) cable for each power source:
Separate grounding (earthing) cable
Shared grounding (earthing) cable, earth socket
Grounding (earthing) cable laid in a loop
Grounding (earthing) cable coiled
Welding circuit
inductivity L,
welding circuit re
-
sistance r
The welding circuit inductivity L and the welding circuit resistance r must be calibrated sep
-
arately for each power source for the "Drive EasyTwin" process.
Material
Shielding gas
Unalloyed and low-alloy steels
ArCO
2
, ArO
2
and ArCO
2
O
2
compounds
Содержание Drive EasyTwin
