FRIULAIR ACT ES 20-500, Руководство по обслуживанию пользователя и запасные части

Страница: 26 / 68

Technical description
26 – EN ACT ES 20 – 500
7.12.6 Operation of the service warning / alarm signal
The DMC 51 is equipped with a 12Vdc signal (max 15 mA) to indicate service warning or alarm conditions.
Dryer is switched on, no service warning and no alarm (active and not yet reset) are
indicated.
Dryer is off or a service warning or an alarm (active and not yet reset) is indicated.
7.12.7 How to change the operating parameters – SETUP menu
The setup menu can be used to change the dryer’s operating parameters.
Only qualified personnel must be allowed to access to the setup menu. The
manufacturer is not responsible for malfunctioning or failure due to modification to the
operating parameters.
With dryer ON simultaneously press buttons
Set
+ for at least 5 seconds to enter the setup
menu.
Access to the menu is confirmed by message
on the display (first parameter of menu).
Keep Set pressed to display the value of the selected parameter and use arrows and
to change the value. Release the button Set to confirm the value and skip to following parameter.
Press + to exit setup menu (if no button is pressed after 30 seconds the menu is exited
automatically).
ID Description Limits Resolution
Standard
setup
HdS - High DewPoint Setting : service warning
threshold for a high DewPoint (the service warning
disappears when the temperature drop 0.5°C / 1°F
below set point)
0.0…25.0
°C or
32 … 77 °F
0.5 °C
or
1 °F
20
or
68
Hdd - High DewPoint Delay : high DewPoint service
warning enable delay 00 … 20
minutes
1 min 15
SrV - Service Setting : setting of service warning
timer.
0.0 = service warning timer disabled. 0.0 … 9.0
(x 1000)
hours
0.1
(x1000)
hours
8.0
SCL - Scale: display scale of temperatures.
°C … °F - °C or °F
ESS – Energy Saving Set: selection if dryer run in
energy saving cycle.
YES = Energy saving mode is active (cycling mode).
nO = Energy saving mode is not active (Hot Gas by-
pass sytem)
YES…nO
-
YES