Fritsch PULVERISETTE 15, Руководство по эксплуатации, Страница: 15 / 19

pulverisette 15 page 12
4.2 Milling process
4.2.1 Attaching the collector
Engage the flange of the choppings collector (3.5-l pot or 30-l container)
in the toggle catches and close both toggles at the same time – the
safety switch should be actuated.
4.2.2 Insert the material to be cut
Note : first turn on the cutting mill, then insert the material.
1. Push in the pusher,
2. Turn on the mill,
3. Open the hopper,
4. Insert the material to be cut,
5. Lift pusher carefully to the end-stop,
6. Slowly lower the pusher and push the material into the cutting
chamber.
7. Note that the material may become heated – allow cool-
ing pauses if necessary!
8. When milling is finished: carefully release the collector
latches.
Release both latches together.
ATTENTION:
Only insert as much material as the machine can reasonably handle.
Excessive quantities can block the mill.
If the mill is blocked, switch it off and clear it of material.
Before restarting, check the blade gap (see section
4.1.2 Checking the
blade gap ).
1, 5, 6
2
3, 4
8