1-800-672-4399
Available exclusively at
PART 3 - OPERATE DOOR, BASE LOCKS AND DOOR LATCH
STEP 1
Locate the base locks at the
bottom of the gate door. Turn one base lock
to the horizontal position to open the gate
door. The base lock on the side occupied
by your pet should be placed in the vertical
position.
TIP:
There are (2) base locks which allows
you to modify how the gate swings open.
TO OPEN DOOR IN AND OUT
Leave all base locks in the horizontal
position. (Figure 3-1).
TO OPEN DOOR IN ONLY
Turn the base lock on the inside of the
gate (where your pet would be) horizontally
(Figure 3-2).
TO OPEN DOOR OUT ONLY
Turn the base lock on the outside of the
gate horizontally.
STEP 2
T
o open the gate door, locate
the door latch. Press both side buttons
on the latch and pull up (Figure 3-3 & 3-4).
Once the gate is opened, it will swing shut
and lock on its own.
KEEPING THE DOOR OPEN
Swing the door past 90 degrees to lock it
open (Figure 3-5).
Figure 3-1
Figure 3-5
Figure 3-3
Figure 3-2
Figure 3-4
REMOVING THE GATE
To remove the gate, rotate the adjustment wheels on the (4) threaded spindle
rods to loosen. This will depressurize the gate so you can remove it with a gentle
pull or push.
CARE AND MAINTENANCE
WARNINGS AND CAUTIONS
Please read all warnings and instructions thoroughly before assembling.
• FOR PET USE ONLY. NOT FOR USE WITH CHILDREN.
• Never install this gate without the wall cups!
• Only assemble as directed and using all required parts.
• Never leave pet unattended. Stop using if/once your pet
can climb over or push the gate loose.
• Use only with the locking/latching mechanism securely
engaged.
• Never use at top of stairs.
• Do not use as a barrier to pool.
• Use the wall cups for stability and safety. Wall cups
and assembly hardware are included.
• Install according to assembly instructions. If installed
improperly, the gate could become unstable or dislodged
from the doorway.
• Always ensure the gate is resting against the floor before
beginning installation.
• Never use more than two extensions per side of gate.
• If assembling onto a surface other than drywall or wood,
please consult with a professional for proper installation.
• Do not assemble if any part is missing or damaged.
• Check the gate regularly to ensure all hardware and
mountings are tightened.
• Keep these instructions handy for future use.
• The gap between the gate and wall should not exceed more
than 2 inches.
Always chec
k the gate and discontinue use if any parts are missing, worn or damaged.
Check regularly to make sure all hardware and mountings are tightened securely.
Wash with mild detergent. Don’t use any abrasive cleaners or bleach.
TROUBLESHOOTING
GATE NOT STAYING CLOSED
The locking handle is too close
to the locking housing. This can
be corrected by loosening the
upper threaded spindle rods by
turning them outward, creating
the proper gap.
GATE NOT STAYING OPEN
The gate was not installed
properly. Remove and reinstall
the gate, being careful to ensure
that the gate is flat, straight, and
perpendicular to the floor.
CALL OUR FRIENDLY CUSTOMER SERVICE TEAM ANYTIME.
WE’RE HERE 24/7! 1-800-67-CHEWY (672-4399)
QUESTIONS?
