FRIGOMAR ENG - CU50VFD-CU70VFD 20190108.doc81218 Page 22 of 24
Frigomar has no control or authority over the selection, location, application, or installation of these
components.
The responsibility of the owner of the equipment includes the following:
1.
To operate the equipment according to the manufacturer’s instructions.
2.
To provide easy accessibility for service.
3.
To check and reset circuit breakers and disconnect before calling for service.
4.
To keep the units clean and free of dirt, to keep the air filters clean as well as the air heat
exchangers.
5.
To keep the condenser coil free of sediment and scale.
6.
To check monthly and replace (if needed) zinc anodes on seawater condenser (if applied).
7.
To keep clean the fan coil water circuit.
8.
To pay the charges incurred when any of the above has not been done.
9.
To pay for repair or replacement of any material or part other than those within the Frigomar
unit.
10.
To check any fuses on the circuit board and replace as required.
This warranty shall not apply to:
Failures resulting from improper or faulty installation, installation that does not comply with Frigomar’s
instructions or otherwise, installation that does not comply with any American Boat and Yacht
Council standards, and any damage resulting from such;
Abuse, misuse of equipment, natural disasters, flooding, fire, submerge, any water leakage, or use
contrary to instructions;
Items not manufactured by Frigomar;
Transport: product damage as a result of improper return packaging or other freight damage;
Negligent servicing;
Wrong electrical and hydraulic connections;
Power supply not in according to manufacturer’s specifications;
Fresh water frosting (chilled water circuit);
Exterior corrosion, electrolysis and galvanism, stray current, seawater erosion;
Water damage, including specifically to the following components: pumps, blowers, logic boards
and displays heads;
Additional labour charges associated with the removal, reinstallation, or replacement of any
equipment or furnishings beyond the particular covered Frigomar product. The original installer or
OEM is responsible for the accessibility of the Frigomar product;
Failures due to improper winterization;
Pumps with cracked heads or pumps that have been run dry, are water damaged or have blown
freeze plugs;
The following components: pump seals, UV light bulbs, sea strainer elements, cartridge filter elements,
sand & gravel in a multi-media filter, pump packing assemblies, pump valve assemblies, pump
crankcase oil, fuses, valve seals and packings, membrane elements and liquid line filter dryers;
Mis-programmed displays;
Logic boards and display heads with water damage;
Environmental and/or recovery fees;
Damages occurring as a result of normal wear or aging;
Replacement of refrigerant with substitute without Frigomar preauthorization;
Welding and Nitrogen Fees.
