11
Preparing and Loading Dishes
(continued)
To install the removable high-side shelf:
1A) Guide the support arms through the lower rack
as shown below.
1B) Align clamps with upper rack wire and press
down firmly to lock into place.
Next,
2A,B) Guide the support arms from the outside to
the inside of the rack.
2C) Slide the shelf to the rear of the rack.
To uninstall repeat the following steps in reverse
order.
Loading the Silverware Basket
Cut Injury
Load sharp items (knives, skewers, etc.) pointing
down.
Failure to do so may result in injury.
Features and appearance of racks and silverware
basket may vary from your model.
Load the silverware basket while it is in the bottom
rack or take the basket out for loading on a
counter or table.
Place small items like baby bottle caps, jar lids,
corn cob holders, etc., in a covered section. Close
the cover to hold small items in place.
Use suggested loading patterns, as shown, to
increase washability of your silverware.
Be sure nothing protrudes through bottom of
basket or rack to block the spray arm.
Do not mix silver and stainless to avoid damaging
the silver finish.
The silverware basket can be separated and
placed in several locations in the bottom rack.
Load silverware in all sections or just one,
depending on your load.
Adding a Dish
To add or remove items after wash cycle starts:
• Unlatch door and wait a few seconds until wash
action stops before opening.
• Add the item and wait a few seconds to allow
cold air to slowly expand inside dishwasher.
• Close door firmly to latch and resume cycle.
