BEFORE OPERATING
10
Exhaust High / Med / Low / Off
The exhaust ventilation removes steam and other cooking
vapors from the cooking surface of the range below the
microwave oven.
To operate the exhaust vent, touch the
pad once for the
highest speed setting. Touch the pad again to
choose the Med speed setting, a 3rd time to
Note: If the temperature gets too hot around the microwave
oven, the fan in the exhaust vent hood will automatically turn
automatically turn off when the internal parts are cool. When
this occurs, the vent cannot be turned off.
Surface Light High / Low / Off
on at the LOW setting to cool the oven. The fan will
Setting the clock
Example: setting clock display for 9:00:
1. Touch
2. Enter time using number pads.
3. Touch
p
ad .
p a d once .
START
Setting the clock ON/OFF
1. Touch
2. Time will display, after 3s, OFF
will display.
OFF
and hold pad .
2. Enter desired time using number pads.
3. Touch
Timer
pad.
When the timer has reached the end of set time, you will
hear beep alerts indicating the timer has run out.
Timer count down does not stop even if the door is opened.
To stop/cancel the timer, press the key
once .
Timer
•
Plug in the oven. Close the door. The oven display
will flash 12:00 ENTER TIME.
•
If no operation after 1 minute, the oven will show
12:01.
1.
Before operating your new oven make sure you read
and understand this Use and Care Guide completely.
2.Before the Built-in Convention Microwave Oven
3. Set clock. See below.
can be used, follow these procedures:
Setting the timer
Example: setting timer for 5 minutes:
1. Touch
Timer
pad once.
2.
1. Clock key (short press <1sec) to enter the
clock query state, display "current clock" for 3
seconds and then return to standby mode, the
clock is not displayed;
Example: to turn off clock display:
Example: to turn on clock display:
Hold Clock button 3s, at beginning, clock
will be displayed then display ON, then
display clock again.
Exhaust High/Med/Low/Off
choose the Low speed setting and a four times
to turn the exhaust ventilation off.
Touch the pad
once to activate the surface light, the screen
Surface Light High/Low/Off
Surface Light High/Low/Off
=displays "HIGH". Continue to touch the
pad, you can
choose the LOW or OFF gear.
