Frigidaire Gallery PLDB998AC0, Инструкция по использованию и уходу

Страница: 15 / 20

15
Overfill Protector
—keeps dishwasher from
overfilling and is located in the left front corner of
the tub.
• Clean occasionally with household
cleaner containing
vinegar or bleach to
dissolve any buildup.
• Overfill Protector should
move up and down
freely about one inch. If
it does not move, lift
and clean underneath.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher and is not covered by
warranty.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher. For cleaning
instructions see “Removing Spots and Film”
section.
Outside
—
Occasionally wipe with a mild
nonabrasive detergent and water. Rinse and dry.
Models with Stainless Steel Door
—
Clean stainless steel door and handle with
Stainless Steel Magic, trademark of Magic
American Corp., or similar product using a clean,
soft cloth. Avoid harsh or gritty cleaners or
scouring pads which may scratch the finish.
Inside
—The inside of the dishwasher is self-
cleaning with normal use. If needed, clean around
the tub gasket area
with a damp cloth.
The filter is self-
cleaning. A glass
trap located in the
center of the filter
is designed to
collect pieces of
broken glass,
straws, bones and
pits. To remove
items in glass trap,
grasp handle, lift
out, empty and replace.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or
tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a POTS PANS cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more
details.
Property Damage Hazard
Freezing temperatures may cause water lines
to rupture. Be sure all supply lines to and
circulating lines within dishwasher are
protected.
Failure to do so could result in property
damage.
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Burn Hazard
Care and Cleaning