Frigidaire FRT21QRJZ3, Руководство пользователя

Страница: 11 / 20

11
7. Trim Removal
(Full-Length Trim
models only)
In some models, the
refrigerator door
has a
full-length
trim piece which
continues from the
bottom of the
handle to the
bottom of the door.
The top of the trim
attaches to the
handle bracket. An
adhesive "trim
lock" is positioned
about half-way
down. The bottom
of the trim is held in
place by either an
adhesive trim lock,
or a trim lock with
two prongs inserted
into a hole on the
face of the door. Remove the trim by gently pulling the trim
lock areas out and away from the door. When the trim is
free from the door, slide the trim straight down and away
from the handle bracket.
For models with short handle trim, remove by sliding the
trim straight down and off of handle bracket.
To remove handles: Remove the three screws attaching the
handle to the refrigerator door. Carefully remove hole plugs
from corresponding holes on opposite side of doors and
reattach handle.
6.To remove
freezer handle:
Magnetic Name-
plate (some
models)
Reverse
handles while doors
are off. Remove the
two screws attaching
the handle to the
bottom of the
freezer door.
Remove short trim piece by sliding the trim straight up and off
of handle bracket. Remove the screw attaching the top of the
handle to door, and reinstall on other side, using the same
holes as the nameplate. To move nameplate to other side,
remove the magnetic nameplate from its frame, turn frame
upside down and install in old handle holes. Insert magnetic
nameplate into frame. Reattach handle to bottom of door.
Slide the trim piece straight down onto handle bracket.
Self-adhesive Nameplate (some models)
Reverse handles while doors are off. Remove the two screws
attaching the handle to the bottom of the freezer door. Remove
short trim piece by sliding the trim straight up and off of handle
bracket. Remove the screw attaching the top of the handle to
door, and reinstall on other side, using the holes found behind
the self-adhesive nameplate. To move nameplate to the other
side, peel off the nameplate and reapply over the old handle
holes. Reattach handle to bottom of door. Slide the trim piece
straight down onto handle bracket.
Freezer Door
Refrigerator Door
To reattach trim: Slide both trim locks out of trim. Insert the
new adhesive trim locks contained in your literature pack.
NOTE: Trim lock must be removed and installed by sliding OVER
the two donut shaped areas. Install trim to handle by sliding up
over bottom of handle. Carefully align trim and press down at
trim lock locations. Replace hole plug on opposite side. Use
rubbing alcohol to remove any adhesive residue from old trim
lock location(s).
For models with short handle trim, slide the trim straight up
onto handle bracket.
8. Remove door
stop from bottom of
freezer and
refrigerator door
and reinstall on
opposite side.
9. If your
refrigerator does
not have a Toe
Grille, use a putty
knife to remove the
plastic plug (not
shown) from front
of base and reinstall
in the opposite set
of lower hinge
holes. Assemble
lower hinge to
cabinet. Install
hinge pin in
opposite hinge hole
from which it was
removed. Install the
washer (some
models) on the
lower hinge pin and
insert hinge screws,
but do not tighten.
Hinges will have to
remain loose against cabinet to align door.
or
10. Turn center
hinge upside down
and secure to
cabinet as shown,
using the screws
which are in the
new holes. Install
refrigerator door on
lower hinge pin.
Align door with
edge of cabinet.
Hold the door on
front of cabinet.
Refrigerator Door
Freezer Door