RAC Through-The-Wall Models
Frigidaire Baseline
Specifications
subject to change.
Plug Type (NEMA)
6-20P
Home Comfort Specifications
•
Product Shipping Weight (approx.) – 80 Lbs.
•
Single phase 3-wire cable, 240 / 208 Volt, 60 Hertz AC only electrical
supply with ground required on separate circuit fused on both sides
of line.
•
Amps @ 240 / 208 Volts = (Cool) 5.1 / 5.3 Amps / (Heat) 15.0 / 13.5 Amps
•
Recommended Circuit Breaker – 20 Amps
•
Unit equipped with 240 / 208V 3-wire power supply cord, NEMA plug
type 6-20P, approximately 72" long.
•
Unit’s increased performance characteristics result from two rear
intakes. For unit to operate at maximum efficiency, carefully follow
complete, detailed new or replacement installation instructions
provided in Product Installation Guide on web.
•
Unit requires rearward slope when installation is complete, to allow
condensate to drain from rear of sleeve.
New Installation
•
For new installation, Frigidaire® Through-The-Wall 18" Sleeve Kit
PN # EA108T available. Recommended for proper installation.
•
Through-the-wall installation requires 18" maximum wall thickness.
•
For energy-saving purposes, install unit in shady location, preferably
a northern exposure; and do not block airflow inside with blinds,
curtains or furniture; or outside with shrubs, enclosures or other
buildings.
Replacement Installation
•
When replacing existing air conditioner with new unit, refer to
Product Installation Guide on web to identify existing wall-sleeve
manufacturer and size compatibility. If proper installation and slope
are suspect, then correct installation of Frigidaire® Through-The-Wall
18" Sleeve Kit PN # EA108T recommended.
•
Use of existing wall sleeve to mount new unit requires original sleeve
be in sound structural condition with rear grille that attaches securely,
or rear flange that serves as stop for unit.
•
Preferable installation option, for increased efficiency and possibility
of drafts reduced, requires existing rear grille
(mounted to sleeve)
be
replaced with new unit’s rear air-directional louvered grille
(provided
in accessory kit, shipped with unit)
. Non-preferable installation option
of directly mounting rear louvered grille to unit can be considered,
requiring grille be mounted to unit prior to sleeve installation.
•
Existing decorative exterior grille may be left in place, provided that
proper air-directional rear louvered grille is installed.
•
For installation into larger existing sleeve, optional Trim Kit
PN # EA120T available.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
Through-The-Wall 18" Sleeve Kit – (PN # EA108T).
•
Trim Kit
(for larger existing sleeve)
– (PN # EA120T).
•
Architectural-Style Exterior Louvered Grille – (PN # EA109T).
Home Comfort
FRA10EHT2
Through-The-Wall Air Conditioner / Heater
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FRA10EHT2 04/11
© 2011 Electrolux Home Products, Inc.
Printed in the U.S.A.
