18
Bearing Glide
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven
light on during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is opened.The oven light may be turned on when the
door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield
held in place by a wire holder.
THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb
and be sure to replace glass shield.
Adjusting Your Oven Temperature
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
Care & Cleaning
Electrical Shock Hazard can occur and result in serious
injury or death. Disconnect appliance from electric power before cleaning
and servicing the warm & Serve drawer.
Removing and Replacing Storage Drawer with
Extendible Glide (some models)
To Remove Storage Drawer:
1.
Open the drawer to the fully opened position.
2.
Locate glide lever on each side of drawer, pull up on the left glide lever and push down
on the right glide lever (See Figure 1).
3.
Pull the drawer away from the range.
To Replace Storage Drawer:
1.
Pull the bearing glides to the front
of the chassis glide (See Figure 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers “click” (approximately 2”). Pull the drawer open
again to seat bearing glides into position.
If you do not hear the levers “click” or the
bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3.
This
will minimize possible damage to the bearing glides.
Removing and Replacing Warm & Serve Drawer
(some models)
Figure 2
Figure 1
Latch
Latch
Left Glide
Right Glide
Pull up latch
with finger
Pull down latch
with finger
To Remove Warm & Serve Drawer:
1.
Turn power off before removing the warm & Serve drawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Figure 1).
4.
Pull the drawer away from the range.
To Replace Warm & Serve Drawer:
1.
Pull the bearing glides to the front
of the chassis glide (See Figure 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers “click” (approximately 2”). Pull the drawer open again to seat bearing glides into
position.
If you do not hear the levers “click” or the bearing glides do not feel seated remove the drawer and repeat
steps 1 thru 3.
This will minimize possible damage to the bearing glides.
NOTE: The Warm & Serve Drawer will
NOT
operate while in the “Self-Clean”
and “Oven Lockout” modes
