FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by tuning the device off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
FCC Interference Statement
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the equipment into an outlet other than the one used for the receiver.
Consult the dealer or an experienced radio/TV technician for assistance.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
This device includes the following module.
Contains FCC ID: 2AIBX-NIUXL
FCC CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Host device Labeling
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum 20 cm between the radiator and your body. This transmitter must not be collocated or
operating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.
RF exposure statement
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
INDUSTRY CANADA (IC) STATEMENT
The antenna (or antennas) must be installed so as to maintain at all times a distance minimum of at least 20 cm between the
radiation source (antenna) and any individual. This device may not be installed or used in conjunction with any other antenna
or transmitter.
RF Exposure
L’antenne (ou les antennes) doit être installé e de façon à maintenir à tout instant une distance minimum de au moins 20 cm entre la
source de radiation (l’antenne) et toute personne physique.
l'exposition aux RF
This device includes the following module.
Contains IC: 21700-NIUXL
Host device Labeling
Ce dispositif inclut le module suivant.
Contient module émetteur IC: 21700-NIUXL
Host dispositif d'étiquetage
This is the location
of the module.
5
.
d
e
v
r
e
s
e
r
s
t
h
g
ir
l
l
A
.
c
n
I
,
s
t
c
u
d
o
r
P
e
m
o
H
x
u
l
o
r
t
c
e
l
E
9
0
0
2
