19
BEFORE YOU CALL
Visit our web site at
www.frigidaire.com.
1-800-944-9044 (United States)
1-800-265-8352 (Canada)
PROBLEM
CAUSE
CORRECTION
AUTOMATIC ICE MAKER
Ice maker is not mak-
ing any ice.
•
Ice maker wire signal arm is in
the “up” or
OFF
position.
•
Ice maker power switch is Off.
•
Ice maker has small cube
caught in mechanism.
•
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
•
Move wire signal arm to the “down” or
ON
position. (side
mounted)
•
Turn power switch to On (“
I
”) position. (rear mounted)
•
Remove small cube from ice maker. The ice and water
filter cartridge may be clogged. Replace filter cartridge.
•
Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
Ice maker is not mak-
ing enough ice.
•
Ice maker is producing less ice
than you expect.
•
Check to see if water dispenser
is dispensing slower than normal.
•
Side mounted ice maker should produce 4 to 4.5 pounds
(approximately 4 quarts) of ice every 24 hours. A rear
mounted ice maker should produce 3 to 4 pounds (ap-
proximately 3½ quarts) of ice every 24 hours. Quick Ice
option should produce up to 50% more ice every 24 hours.
• If it is, replace the ice and water filter cartridge.
Ice maker will not stop
making ice.
•
Ice maker wire signal arm is
being held down by some item
in the freezer.
•
Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
Ice cubes are freezing
together.
•
Ice cubes are not being used
frequently enough.
•
Ice cubes are hollow (partially
frozen cubes with water inside).
•
Freezer control is set too warm.
•
Remove ice container and discard ice from container. Ice
maker will produce fresh supply.
• The ice and water filter cartridge may be clogged. Replace
filter cartridge.
•
Set freezer control to colder setting. Allow 24 hours for
temperature to stabilize.
ICE DISPENSER
Dispenser will not dis-
pense ice.
•
Ice storage container is empty.
•
Freezer temperature is set too
warm.
•
Household water line valve is
not open.
•
Ice dispensing arm has been held
in for more than 4-5 minutes.
• When the first supply of ice is dropped into the container,
the dispenser should operate.
•
Turn freezer control to a higher setting so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
• Open household water line valve. Allow sufficient time
for the ice to be made. When ice is made, the dispenser
should operate.
•
Motor is overloaded. Motor over load protector will reset in
approximately 3 minutes. Ice can then be dispensed.
Ice dispenser is
jammed.
•
Ice has melted and frozen
around auger due to infrequent
use, temperature fluctuations,
and/or power outages.
•
Ice cubes are jammed between
ice maker and back of ice
container.
•
Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
•
Remove ice cubes that are jamming the dispenser.
OPENING/CLOSING OF DOORS/DRAWERS
Door(s) will not close.
•
Door was closed too hard, caus-
ing other door to open slightly.
•
Refrigerator is not level. It
rocks on the floor when moved
slightly.
•
Refrigerator is touching a wall
or cabinet.
•
Close both doors gently.
• Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
• Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Drawers are difficult to
move.
•
Food is touching shelf on top of
drawer.
•
Track that drawers slide on is
dirty.
•
Remove top layer of items in drawer.
•
Ensure drawer is properly installed on track.
•
Clean drawer, rollers, and track. See Care & Cleaning.
