23
Locating the Filter
Your refrigerator is equipped with a water filtering
system. The water filter system filters all dispensed
drinking water, as well as the water used to
produce ice.
Water Filter
The water filter is located at the top right side of
the fresh food compartment.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
and
PureSource 3
TM
ice and water filter
•
Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
To replace your PureSource 3
TM
water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the filter
replacement.
1
Turn
Off
the ice maker.
2
Remove the filter by pushing on the end/face
of the filter.
3
Slide the old water filter cartridge straight out
of the housing and discard it.
4
Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snap-in
connector at the back of the housing.
5
Push firmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector).
6
Press a drinking glass against the water
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
7
After filling one glass of water, continue
flushing the system for about
four minutes
.
8
Turn
On
the ice maker.
9
Press and hold the
Water Filter
button on
the Ice & Water Dispenser control panel for
three seconds. When the display changes from
“
Red
” to “
Green
,” the status has been reset.
Ordering Replacement Filters
To order your replacement filters, please visit our
online store at www.frigidaire.com/store, by calling
toll-free at 877-808-4195, or by visiting the dealer
where you purchased your refrigerator. Frigidaire
recommends that you order extra filters when you
first install your refrigerator, and that you replace
your filters at least once every six months.
Here are the product numbers to request when
ordering:
PureSource Ultra
TM
Water Filter
Part#
ULTRAWF
PureSource 3
TM
Water Filter
Part #
WF3CB
Replacing the Water Filter
In general, you should change the water filter every six
months to ensure the highest possible water quality.
Water
Filter Status
on the user interface prompts
you to replace the filter after a standard amount of
water (200 gallons/757 liters for
PureSource Ultra
TM
and
PureSource 3
TM
)
has flowed through the system.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
Filter Cartridge
The
PureSource 3
TM
ice and water
filter system is tested and certified to
NSF/ANSI Standards 42 and 53 for
the reduction of claims specified on
the performance data sheet.
More about your Advanced Water
Filter
NOTE
If your refrigerator is equipped with a
PureSource
3
TM
water filter, it can be replaced with a
PureSource Ultra
TM
water filter. Replacing your
PureSource 3
TM
water filter with a
PureSource
Ultra
TM
water filter removes more potential
contaminants as tested by NSF. The contaminants
or other substances removed or reduced by this
water filter are not necessarily in all users’ water.
CHANGING THE FILTER
NOTE
If your refrigerator is equipped with a
PureSource
Ultra
TM
water filter, it must be replaced with
PureSource Ultra
TM
water filter
ULTRAWF
.
The
PureSource Ultra
TM
ice and
water filter system is tested and
certified to NSF/ANSI Standards 42 and
53 for the reduction of claims specified
on the performance data sheet.
