4
nOtE
The exterior walls of the beverage cooler may become
quite warm as the compressor works to transfer heat
from the inside. Temperatures as much as 30° F
warmer than room temperature can be expected. For
this reason it is particularly important in hotter climates
to allow enough space for air circulation around your
appliance.
Leveling
The beverage cooler must have all bottom corners resting
firmly on solid floor. The floor must be strong enough
to support a fully loaded beverage cooler. nOtE: It is
Very Important for your appliance to be level in order to
function properly. If the appliance is not leveled during
installation, the door may be misaligned and not close
or seal properly, causing cooling, frost, or moisture
problems.
To Level Your Beverage Cooler:
After removing all interior and exterior packaging
materials, use a carpenter’s level to level the beverage
cooler from front-to-back. Adjust the leveling legs in
front, ½ bubble higher, so that the door closes easily
when left halfway open.
Cleaning
Wash any removable parts of the beverage cooler
•
interior, and exterior with mild detergent and warm
water. Wipe dry. Do not use harsh cleaners on these
surfaces.
Do not use razor blades or other sharp instruments,
•
which can scratch the appliance surface when
removing adhesive labels. Any glue left from the tape
can be removed with a mixture of warm water and
mild detergent, or touch the residue with the sticky
side of tape already removed. Do not remove the
serial plate.
Important Safeguards:
Do not store food in your wine
cooler as interior temperature may not get cool enough
to prevent spoilage. In summer months or areas of high
humidity, the glass door may build up moisture. To
remove the moisture, wipe it away.
Handle Installation
Place handle over the two mounting studs located at
1.
top of door.
Use hex head screw driver or allen wrench to tighten
2.
set screws from bottom to secure handle to door.
� Handle
ĸ
Wooden Shelf Made of Beech
Ĺ
Control Panel
� Glass Door
� Control Switch of Lamp
� Adjustable Leg
Placement of Wine Cooler
The wine cooler should be placed in dry and ventilated room. The location of
the wine cooler should not be irradiated by direct sunshine. The wine cooler
should be far away from heating sources, such as: cooking stove or heating
radiator. If the wine cooler has to be placed near heating source, please adopt
proper heating insulation board for insulation or keep the wine cooler at least
the following minimum distances away from the heating sources:
For electric stove: 3
.
For oil or coal stove: 30
.
Replacement of Door Hinge
The door hinges of this wine cooler can be interchanged between the left and
right sides.
Installation of Handle
1. Set the handle on the fixation shaft.
Fixation Shaft of Handle
Set Handle
2. Screw down the fixation pins of the handle with screw driver.
- 7 -
Mounting stud
Locate handle
Set screws
InStALLAtIOn
This Use & Care Guide provides general operating
instructions for your model. Use the appliance only as
instructed in this Use & Care Guide.
Before starting the
appliance, follow these important first steps.
Location
Choose a place that is near a grounded electrical
•
outlet.
Do Not
use an extension cord or an adapter
plug.
For optimal performance, it is recommended
•
that you install the appliance where the ambient
temperature is between 70 and 78 degrees
fahrenheit.
Allow space around the unit for good air circulation.
•
Leave a 2 inch space on the back and sides of the
wine cooler for adequate circulation.
Be sure the appliance stays in the upright position
•
during transport.
Keep the appliance from any hazardous or
•
combustible agents.
