6
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
3. Tighten each screw finger tight or until spacers
are snug against burner box walls.
4. Prior to tightening installation screws, exert
downward pressure on burner box to assure
flanges on burner box rest firmly on counter.
Tighten all screws evenly.
5. Unit clamp down information. Once unit is
installed in counter opening, you must clamp unit
down as shown in figure 14.
6. Make electrical connections as outlined in
"Electrical Connection" Section.
Checking Operation
Refer to the Owner's Guide for operation.
CAUTION
Do not touch cooktop glass or elements.
They may be hot enough to burn.
Model and Serial Number Location
The serial plate is located under the cooktop or in the
burner box and can be seen by lifting up the main top of
unit.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before You Call for Service
Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
in this appliance.
Refer to the warranty in your Owner's Guide for our
service phone number and address. Please call or write if
you have inquiries about your product and/or need to
order parts.
Figure 12
Reach down through surface unit openings and install the four
hold down retainers with screws as shown. Be certain cooking
top is firmly retained to counter top.
COOKTOP
BURNER BOX
HOLD DOWN
R E T A I N E R
COUNTERTOP
4. Models: 30" and 36"
(36" X 21½")
Coil Elements
Cooktops
- These cooktops are designed to fit various cutout
sizes. The minimum and maximum cutout openings
are shown in figure 1.
- If cooktop is to be used in new installation, use
minimum cutout dimensions in figure 1.
- Attach cooktop to cabinet using wood screws
through holes in vertical walls of burner box.
-
If cooktop is to be installed as a replacement
in an existing countertop opening (not
exceeding maximum cutout dimensions as
shown in figure 1), the following steps must
be taken:
1. Insert 4 screws and installation spacers through
holes in vertical walls of burner box (see figure
13).
2. Place cooktop into countertop opening and
center unit in cutout.
Figure 14
To clamp down, insert bracket with offset side of angle into slot
on each side of unit. The screw should then be run through
bracket and against bottom of counter. Tighten until draws
down.
COUNTERTOP
COOKTOP
HOLD DOWN
R E T A I N E R
S C R E W
BURNER BOX
NYLON SPACER
Figure 13
BURNER BOX
SCREW
SPACER
