Frigidaire FDB2410HIB - Full Console Dishwasher, Обслуживание, Страница: 46 / 52

Section 4 Component Teardown
4-12
Wash Sump Removal
1. Disconnect power and turn off the water supply to
the dishwasher before starting this repair.
2. Remove upper and lower rack, kickplate and outer
door panel.
3. Before removing the incoming water line to the
dishwasher, place protection under the water valve
to catch any water that will be in the line as it is
removed.
4. Remove as much water as possible from sump.
5. Remove lock ring from inside sump by turning
counter clockwise, a pair of slip jaw pliers may be
used. Place into sump as shown to turn lockout of
sump. (See Figure 4-34)
6. Remove unit from under counter top.
7. Lay unit on its back. Make sure there is protection
for the floor before unit is laid down.
8. Remove hoses from sump. The hose from the
pressure switch, which is mounted to the air
chamber of the sump, is easier to remove if it is
pushed from the sump and not pulled off by the
hose. (See Figure 4-35)
9. Disconnect the safety thermostat and thermistor at
quick disconnect.
10. Carefully remove thermostat mount from the sump.
As the mount is removed, use care and watch for
the two small springs in the mount over the
thermostat and thermistor as they can be easily lost.
11. Install thermostat, thermistor and mount onto new
sump. Do not remove any of the thermalmastic
from tub bottom. Install sump gasket into the top of
new sump.
12. Place sump into the tub. There is a square locator
in the sump, this is to help position the sump
properly before locking it in place. Install sump lock.
13. Reinstall all hoses, making sure they are not kinked,
and then clamp in place.
14. Continue to complete repair in reverse order.
Fill hose from air gap
Pliers
Removing
Lock
Lock Ring
Hose to wash pump
Hose to drain pump
Figure 4-34.
Figure 4-35.