7
Air Conditioner Features
(continued)
YOU WILL SEE:
TO OPERATE ON FAN ONLY:
Note: Use this function only when cooling is not desired, such as for room air circulation.
You can choose any fan speed you prefer,EXCEPT AUTO FAN.
During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode.
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
DO THIS:
PRESS
MODE BUTTON
CHOOSE
POWER SAVER
YOU WILL SEE:
TO USE THE
POWER SAVER FEATURE:
Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the unit cooling system
YOU WILL SEE:
TIMER-DELAY
START/STOP FEATURE:
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow(^) or DOWN arrow (v) to change the delay time by .5 hour increments up to
10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.).
The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as
previously set. To change the set temperature, press “COOL” then Up or Down arrows until the desired temperature is indicated
on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will
start/stop. Turning the unit “ON” or “OFF” at any time will cancel the Delay Start/Stop function.
starts again.
THEN
DO THIS:
PRESS TEMP/TIMER
TIMER BUTTON
FIRST
DO THIS:
PRESS TIMER
BUTTON
