34
CARE AND CLEANING
Replacing the Oven Light
Replacing the oven interior light bulb:
The interior oven light is located at the rear of the oven
cavity and covered with a glass shield. The glass shield
must be in place whenever the oven is in use (
).
1.
Turn electrical power off at the main source or unplug
the appliance.
2.
Remove the interior oven light shield after removing the
wire holder by carefully moving the wire to the side of
the glass shield. The tension from the wire holds the
glass shield in place.
3.
Pull the shield straight out. Do not twist or turn.
4.
Replace the bulb with a new appliance bulb.
5.
Replace the glass oven light shield. Replace wire
holder.
6.
Turn the power back on again at the main source (or
plug the appliance back in).
7.
Be sure to reset the time of day on the clock.
Remove and replace storage drawer (some
models)
Use the storage drawer for storing cooking utensils. The
drawer can be removed to facilitate cleaning under the
range. Use care when handling the drawer.
To remove the drawer:
1.
Pull empty drawer out until it stops.
2.
Tilt up the front of the drawer up and pull it out over the
glide stop.
To replace the drawer:
1.
Insert the back of the drawer into the opening.
2.
Lift up the drawer and line up the drawer supports with
the rails. Make sure to clear the glide stop.
3.
Push in the drawer until it stops.
Be sure the oven is unplugged and all parts are cool
before replacing the oven light.
Figure 34: Oven light protected by glass shield
CAUTION
wire
holder
glass
shield
Figure 35: Parts of storage drawe
r
glide stop
glide rail
drawer support
