19
Be careful
not to bend terminal ends
when replacing elements
after cleaning.
Care & Cleaning
(Cleaning Chart)
Oven racks should be removed, or else their finish will dull and their color turn slightly
blue. If they do go through the self-clean cycle, wait until the oven has cooled, then remove
the oven racks and rub their sides with wax paper or a cloth containing a small amount of
baby or salad oil; this will make the oven racks glide easier back in and out of their
positions.
To clean oven door, wash with hot, soapy water and a clean cloth. DO NOT immerse the
door in water.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven material,
on self cleaning models, which is essential for a good seal. Care should be taken not to
rub, damage or remove the gasket.
Oven Racks
Oven door
Do
Not
Hand
Clean Seal
Do
Hand
Clean
Frame
Do
Hand Clean Door
Cooktop Cleaning - Coil Surface Element Models Only
To Remove and Replace Surface Elements and Drip Bowls
(some models)
ATTENTION:
Never leave covers on the coil elements as they could be permanently dam-
aged if the coil is turned on by accident.
Prior to cleaning the coil elements make sure they are cold and that control knobs are
turned to OFF
Coil elements clean themselves when they are turned on.
Coil elements and drip bowls are removable and allow to clean the drip bowls.
To remove a coil element, push against the front edge and lift element up and out.
To clean by hand, wash the drip bowls in hot sudsy water. For hard to remove spots, use ny-
lon scrubber with soap. Rinse and dry will still warm.
Never immerse coil elements in water.
INSTRUCTIONS
Use a damp sponge or dampened soap pad, rinse
and dry.
Use a clean soapy, dampened cloth or paper towel,
remove soil and dry. Do not use abrasive products.
CLEANING AGENTS
Mild cleaners or a non abra-
sive soapy pads.
Hot, soapy water or cleaner
cream.
SURFACES
Porcelain enamel
(cooktop, surface under
cooktop)
Insert - Control Panel
