9
RIGHT
REAR
RIGHT
FRONT
LEFT
FRONT
LEFT
REAR
LEFT
REAR
LEFT
FRONT
RIGHT
FRONT
RIGHT
REAR
Setting Surface Controls
Operating the Gas Surface Controls:
1.
Place cooking utensil on surface burner.
2.
Push the surface control knob down and turn
counterclockwise
out of the OFF
position.
3.
Release the knob and rotate to the LITE position (see figure 2). Note: All four
electronic surface ignitors will spark at the same time. However, only the burner you
are turning on will ignite.
4.
Visually check that the burner has a flame.
5.
Turn the control knob
counterclockwise
to the desired flame size. The control
knobs do not have to be set at a particular setting. Use the knob indicator settings
to adjust the flame as needed.
DO NOT
cook with the surface control knob in the
LITE position. (The electronic ignitor will continue to spark if the knob is left in the
LITE position.)
Control Locations of the Gas Surface Burners
Your range is equipped with gas surface burners with 3
different BTU ratings. The ability to heat food quicker and
in larger volumes increases as the burner size increases.
The small
SIMMER
burner is best used for simmering
delicate sauces, etc. This burner is located at the right rear
burner position on the cooktop (see figure 1).
The
STANDARD
burners can be used for most surface
cooking needs. The 2 burners are located at the left front and
rear burner positions on the cooktop (see figure 1).
The
POWER
burner is best used for bringing large quantities
of liquid rapidly up to temperature or when preparing larger
quantities of food. The POWER burner is located at the left
front burner position on the cooktop (see figure 1).
Regardless of size, always select cookware that is suitable
for the amount and type of food being prepared. Select a
burner and flame size appropriate to the pan. Never allow
flames to extend beyond the outer edge of the pan.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use.
These items could melt or ignite. Potholders, towels or wood spoons could catch fire
if placed too close to a flame.
In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match
to the burner head, then slowly turn the surface control knob to
LITE
. After burner lights turn the knob to desired setting. Use
caution when lighting surface burners manually.
Figure 1
Figure 2
