Frigelux RF 240A+, Инструкция по эксплуатации

Страница: 24 / 30

○
,
1.
Turn the thermostat to the off positin "0" and disconnect from the mains.
○
,
2.
Remove all the food from the top shelf of the fridge and pull it forwards slightly.
○
,
3.
The lamp is located in the back of the thermosat housing, remove the plastic lens by pressing the front centre of the lens whilst pulling upwards on the
small lip on the bottom of the lens at the front.
○
,
4.
Unscrew the lamp in a clockwise direction and screw a new lamp into the lamp holder in an anti-clockwise direction until finger tight.
○
,
5.
Replace the lens by locating the rear lug and pressing home firmly.
○
,
6.
Set the thermostat to your preferred setting and close the door.
How to maintain and clean
1. Defrost
If there is frost build up on the evaporator plate the unit needs to be defrosted. When you defrost, please remove all the food and turn the
thermostat to defrost, and close the door.
Note: if want to speed up the defrost rate, place a bowl of hot water on the rack and close the door.
Please don’t use any solid or sharp object or electric heater to defrost as this will damage the evaporator.
2. Clean
The inside of the refrigerator needs to be cleaned in order to avoid unpleasant odours.
First, switch the unit off.
Use soft wet towel to wipe down the interior and dry with a cloth wiping away any marks.
Note: Avoid pouring water on the outside of the refrigerator as this will affect the insulation of the machine.
Don’t use hot water, acid, alkali, gasoline, benzene, caustic cleanser, alcohol, and hard brush to wipe the plastic parts.
3. Operating of the refrigerator
It’s better to allow the refrigerator to run for longer periods than switching the unit on and off, even if there is no food in unit, This will
extend the life of the unit.
4. Storage after use