*
**
2
Packaging contents
1x LED luminaire
1x Manual
1x Frame
General safety instructions
Please read the operating instructions for the LED luminaire
before use. The operating instructions are part of the product.
They contain important notes on start-up and handling of the
device. Always keep the enclosed operating instructions so as
to be able to look up information. They must be enclosed when
passing the device on to third parties.
Safety precautions
The user must observe the safety notes and warnings in order
to maintain this status and to ensure safe operation. Please
read the operating instructions before start up.
Never attempt to open the device, the LED luminaire cannot
be repaired; this part must be immediately disposed in case
of a defect. Ensure sufficient ventilation of the device. Never
cover it during operation.
Any other use of the device than described can damage the
product or endanger the user due to e. g. short-circuits, fire
or an electric shock. The entire product may not be modified
or adapted.
These safety notes must be observed in all cases!
Any warranty claim is void in the case of damag-
es caused by non-observance of these operating
instructions. We are not liable for consequential
damages or for damages to property or persons
caused by non-observance of the safety notes
and improper operation of the device.
Safe operation is not possible anymore, if:
- the LED luminaire has visible damages,
- the LED luminaire does not work anymore
Safety notes
LED-lights are extremely bright. Under no cir-
cumstances look into the light beam of the LED
lights, as this may cause permanent damage to
your eyes.
*If the glass is broken, it has to be replaced with
a new original protective glass before further
use.
**FIRE HAZARD! Fit the light so that it is at least
1 m away from the material to be illuminated.
Excessive heat can result in a fire.
RISK OF INJURY FROM BURNS! Ensure the light
has been switched off and allowed to cool before
you touch it.
„To prevent hazards, a damaged flexible outer
lead of this light may only be exchanged by
the manufacturer, his service representative or
by an equally qualified specialist.
warning:
Plug is
IP44
GB
Notes on Disposal
The product is designated for separate collection at an appropriate collection point.
Do not dispose of the product with household waste. For more information, contact
the retailer or the local authority responsible for waste management.
Care
Before cleaning the unit, disconnect it, if necessary form other components; do not use aggres-
sive cleaning agents.
Warranty
The unit has been carefully checked for defects. If nevertheless you do have cause for complaint,
please go back to the retailer where you have bought the product together with your proof of
purchase.
Safety
General advices
●
Read the manual carefully before use. Keep this manual for future reference.
●
Only use the product for its intended purposes. Do not use the product for other purposes
than described in the manual.
●
Do not use this product if any part is damaged or defective. If the product is damaged or defec-
tive, replace the product immediately.
●
This product Must not be used in the immediate viciity of children without the supervision of
an adult. Children must not be allowed to play with the device.
●
Do not modify the product in any way.
○
Do not expose the product to water or moisture. (IP 20)
○
Do not immerge the product into water. (IP 44 – IP 66)
●
Keep the product away from heat sources.
●
Do not block the ventilation openings.
●
Do not look directly into the light source of theLED lamp.
●
Keep a minimum distance of >2 meter between the lamp and the surface being illuminated.
Electrical safety
●
To reduce risk of electric shock, this product should only be opened by an authorized techni-
cian when service is required.
●
Do not use the product if the cable or plug is damaged or defective. When damaged or defec-
tive, it must be replaced by the manufacturer or an authorised repair agent.
●
Before use, always make sure that the voltage is the same as the voltage on the rating plate
of the device.
●
Make sure that the cable does not hang over the edge of a worktop and cannot be caught
accidentally or tripped over
Warning
●
The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person.
●
Caution, risk of electric shock.
●
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged,
the luminaire has to be destroyed.
Disclaimer
We reserve the right to make technical modifications. without notice. All logos, brands and
product names are trademarks or registered trademarks or their respective holders and are
hereby recognized as such.
We are not liable for damage arising from incorrect handling, improper use or wear or tear.
Please visit us online
For more information about our company and our products,
Documentation
The product has been manufactured and supplied in compliance with all relevant regulations
and directives, valid for all member states of the European Union. The product complies with all
applicable specifications and regulations in the country of sales.
Formal documentation is available upon request.
The formal documentation includes, but is not
limited to the Declaration of Conformity, the Material Safety Data Sheet and the product test
report.
CE declaration
This product complies with the following directives:
LVD: 2014/35/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
The complete Declaration of Conformity
Document (DOC) can be found here:
Interseroh: 95413
Imported by
Friess-Techno-Profi GmbH
Landsberger Str. 98b
45219 Essen
www.friess-techno.de
30W
Art-.Nr.: 554030
50W
Art-.Nr.: 554050
GB
Installation and Operating Manual
Safety Class I
Specifications
Art Nr.
Power (W):
Input voltage (V AC):
Power factor
Luminous flux (lm):
Lumen/W
Equivalent Light output(W):
Color temperature (K):
Color description
Lifespan(h):
Switching cycles (on/off):
Beam angle:
Warm up-time (95%):
Dimensions lamp(LxWxH mm):
Dimensions Rack(LxWxH mm):
Colour rendering index (CRI):
Energy class:
Driver:
LED type:
Protection class IP:
Dimmable
Cable type:
Plug type
Working temperature (T °C):
Housing:
554030
554050
30
50
230V / 50 Hz - 145mA
230V / 50 Hz - 217mA
>0,95
1.700
2.450
55
50
125W
180W
4.000
20.000
15.000x
120°
<0,5s
55 x 185 x 145
225 x 60 x 185
230 x 195 x 300
275 x 228 x 375
Ra>95
A
230V direct drive LED PCB
2835 SMD (56x)
IP65
No
1,5 m, H07RN-F 3G1,0mm²
IP44
-20°C ≤T ≤40°C
Aluminium, powder coated
Neutral white
file name: 300650FRI,300651FRI-MAN-ML-201800605-FRI 554030, 554050.indd - Printfile created on: 20180605 09:50 - Design: WILLY
MV#: 20180605 09:50
300650FRI,300651FRI-MAN-ML-201800605-FRI 554030, 554050.indd 2
2018-06-05 09:51:22