FriendlyARM NanoPi NEO Plus2, Руководство пользователя

Страница: 9 / 13

Ethernet Connection
If the NanoPi NEO Plus2 is connected to a network via Ethernet before it is powered on it will automatically
obtain an IP after it is powered up. If it is not connected via Ethernet or its DHCP is not activated obtaining an IP
will fail and system will hang on for about 15 to 60 seconds. Obtain an IP address
dhclient
eth0
Login via SSH
The NanoPi NEO Plus2 doesn't have a video output interface. You can log into the board via SSH. In our test the
IP address detected by our router was 192.168.1.230 and we ran the following command to log into the NanoPi
NEO Plus2:
$ ssh
root@192.168.1.230
The password is fa
Extend NEO Plus2's TF Card Section
When Ubuntu is loaded the TF card's section will be automatically extended.You can check the section's size by
running the following command:
$ df -
h
Wireless Connection
Note: An IPX antenna is A MUST.
After your NanoPi NEO Plus2 is powered up you can log into NEO Plus2 and run the following command to
check if a WiFi device is recognized. If "wlan0" is listed it indicates your WiFi has been recognized:
sudo ifconfig -a
9/13