background image

10

THIS APPLIANCE MUST BE EARTHED. 
This appliance is fitted with a fused three pin plug to BS 1363  
which will be suitable for use in all houses fitted with sockets to  
current specifications.

If the fitted plug is not suitable for your socket outlets, it should be cut  
off and carefully disposed of. To avoid a possible shock hazard, do not 
insert the discarded plug into a socket.

Fitting a new plug

If for any reason you need to fit a new plug, the flexible mains lead must 
be connected as shown here. 

CONNECT GREEN
AND YELLOW TO EARTH (E) 
(Note: some appliances do 
not have earth wires.)

CONNECT BLUE TO 
NEUTRAL (N)

MAKE SURE THE CABLE 
IS HELD BY THE CLAMP

CONNECT BROWN 
TO LIVE (L)

ELECTRICAL CONNECTIONS

The wires in the mains lead fitted to this appliance are coloured in  
accordance with the following code:

If the colours of the wires in the mains lead of this appliance do not  
correspond with the coloured markings identifying the terminals in your 
plug, proceed as follows:

The wire which is coloured Green and Yellow MUST be connected to the 
terminal which is marked with the letter E (Earth) or symbol 

 or 

coloured Green. The wire which is coloured Blue MUST be  connected 
to the terminal which is marked with the letter N or coloured Black. The 
wire which is coloured Brown MUST be connected to the terminal which 
is marked with the letter L or coloured Red.

Before refitting the plug cover, check that there are no cut or stray 
strands of wire inside the plug.

Use a 13 Amp BS1362 fuse, only BSI or ASTA approved fuses should be 
used. If you are in any way unsure which plug or fuse to use, always refer 
to a qualified electrician.

Note: After replacing or changing a fuse on a moulded plug which has 
a fuse cover, the cover must be refitted to the plug, the appliance must 
not be used without a fuse cover. If lost, replacement fuse covers can be 
obtained from an electrical shop.

This appliance complies with the following EEC Directives: 73 / 23 EEC 
(Low Voltage Directive) 89 / 336 EEC (EMC Directive).

Содержание MUR49100













Отзывы: