Fridgemaster MBUR60121MF, Руководство пользователя, Страница: 11 / 17

Cleaning and Care
For hygienic reasons the appliance
(including exterior and interior accessories)
should be cleaned at least every two
months.
Warning!
To avoid electrical shock, the appliance
must not be connected to the main power
supply during cleaning. Before cleaning,
switch the appliance off and remove the
plug from the main socket.
Exterior cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Spray water onto a cleaning cloth instead
of spraying directly on the surface of the
appliance. This helps ensure an even
distribution of moisture to the surface.
Clean the doors, handles and cabinet
surfaces with a mild detergent and then
wipe dry with a soft cloth.
●
Caution!
Don’t use sharp objects to clean with, as
they are likely to scratch the surface.
Don’t use Thinner, Car detergent, bleach,
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning.
They may damage the surface of the
appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low. Wipe the inside of the
fridge freezer with a weak solution of
backing soda and water, and then rinse
with warm water using a wrung
●
-out
sponge or cloth. Wipe completely dry
before replacing the shelves and baskets.
Thoroughly dry all surfaces and removable
parts before putting them back into place.
This appliance manually defrosts, a layer
of frost may occur on the fridge
compartment’s interior walls if the fridge
door is opened frequently or kept open too
long. If the frost is too thick, choose a time
when the fridge is nearly empty and
proceed as follows:
1. Remove existing food and accessories
baskets, unplug the appliance from the
main power and leave the doors open.
Ventilate the room thoroughly to
accelerate the process.
2. When defrosting is completed, clean
your fridge as described above.
Warning!
Do not use sharp objects to remove frost
from the freezer compartment. Only after
the interior is completely dry should the
appliance be switched back on and
plugged back into the main socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick to
the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light
Warning: The LED light must be replaced
by a competent person. If the LED light is
damaged, follow the steps below:
1. Unplug your appliance.
2. Remove light cover by rising up and
pulling out the LED light.
3. Hold the LED light with one hand and
pull it with the other hand while pressing
the connector latch.
4. Replace LED light and snap it correctly
in place and recover the light cover.
11