FRICON HCE, Руководство по эксплуатации и обслуживанию

Страница: 33 / 76

THG THB HCE HDNL English
31
•
The refrigerator circuit’s exterior (compressor,
condenser, connection tubes, and remaining
components) must be cleaned with a soft
brush or vacuum cleaner.
•
Pay special attention while cleaning the
condenser. If obstructed, it will affect the
equipment’s performance.
•
While cleaning, be careful not to twist the tubes
or disconnect cords.
Cleaning Glass Doors:
•
Cleaning with abrasive microfibers cloths and all types of coarse sponges is not
allowed.
•
Make sure to avoid large quantities of water from being applied on glass surfaces
when being cleaned and that the surfaces are thoroughly dried afterwards.
•
You can only clean the inside of the lid with a soft cotton cloth moistened with the
following solution: 90% distilled water + 10% isopropyl alcohol to clean the entire
area. Cleaning products can destroy the coating.
•
The outer part of the lid can be cleaned with normal cleaning products.
NOTES:
•
Do not use abrasive materials or mops as they will definitively damage the
equipment’s surface.
•
Do not remove fixed parts for cleaning. If necessary, they must be cleaned by
qualified personnel.
•
Do not use hot water on glass doors while they are cold: the temperature difference
might break the glass.
Component Replacement
:
If any component of the equipment is damaged, it must be replaced by personnel
properly qualified for this task.
10. Problem Resolution Guide
10.1 The equipment is not working
•
Check if there is electrical current.
•
Check if the plug is properly inserted in the source outlet and if the voltage and
frequency are appropriate for operation.
10.2 The temperature is not satisfactory
•
Check if the equipment has been connected long enough to have reached
operation temperature.
•
Check if the equipment is away from heat sources.
•
Check if the doors are properly closed.
•
Check the temperature regulation.
NOT TO USE SHARP
OBJECTS NEAR THE
CONDENSER.