°C
6
Tiger 20-30 kW
Type
Cable
IEC60309
271754
TIG203-0
4G6x2m
CP 432-6
271758
TIG303-0
4G10x2m
-
281180
TIG203-0AU
4G6x4m
CP 432-6
EN
Installation and operating instructions
Maintenance
The motor and other components are
maintenance-free. Dust and dirt may cause
overheating and danger of fire. The appliance
must therefore be cleaned regularly.
Residual current circuit breaker
When the installation is protected by means of
a residual current circuit breaker, which trips
when the appliance is connected, this may be
due to moisture in the heating element. When
an appliance containing a heater element has
not been used for a long period or stored in
a damp environment, moisture can enter the
element.
This should not be seen as a fault, but is
simply rectified by connecting the appliance to
the main supply via a socket without a safety
cut-out so that the moisture can be eliminated
from the element. The drying time can vary
from a few hours to a few days. As a preventive
measure, the unit should occasionally be run
for a short time when it is not being used for
extended periods of time.
Packaging
Packaging materials are chosen with
consideration to the environment and are
therefore recyclable.
The mode selector has two different fan
speed positions.
Output is set via the output selector, for
steps see table.
Built-in thermostat with setting range
5–35°C.
Control
The unit is equipped with mechanic thermostat
room temperature control and can be used as
a local space heater according to Ecodesign
Regulation (EU) 2015/1188.
Start-up
When the unit is used for the first time or after
a long period of non-use, smoke or an odour
may result from dust or dirt which has collected
on the element. This is completely normal and
disappears after a short time.
General Instructions
Read these instructions carefully prior to
installation and use. Keep this manual for future
reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid should the product be used
in the manner intended and in accordance with
the instructions.
Application
Tiger is a range of robust and compact fan
heaters for professionals with high demands.
The Tiger fan heater is portable. Tiger 20 and
30 kW are ideal for heating and drying larger
premises such as industrial premises and
workshops, where higher outputs are required.
Protection class: IP44.
Connection
The Tiger fan heater is equipped with a
1.8 metre long connection cable. The special
variant TIG203-0AU has a 4 metre long cable.
TIG203-0 and TIG203-0AU have a 5-pin plug (IEC
60309, IP44, 32A) fitted on the connection cable.
TIG303-0 is supplied with a cable without a plug.
Overheating
The fan heater is equipped with an overheat
protection. If it is deployed due to overheating,
reset as follows:
1. Disconnect the power supply with the isolator
switch.
2. Determine the cause of overheating and
rectify the fault.
3. Reset by opening the lid and pushing the red
button on top of the overheat protection until
a click sound is heard. Fig. 1
4. Put the lid back on and reconnect the heater.
NOTE! All work inside the unit’s connection area
must be carried out by a qualified technician and
with the power supply disconnected.
