Soloclim
17
EN
Trou leshooting
Action
Cause
Symptom
The unit does not work.
The power is not connected.
Insert the plug into the wall outlet and push the ON button.
The filter is clogged.
Clean the filter.
Make sure the air inlet and outlet are not obstructed.
The air does not pass freely through
the unit.
If the fault cannot be rectified, please contact a qualified service technician.
There is too much ventilation.
Reduce ventilation, close doors and windows.
Check and, if necessary, adjust the temperature settings.
The desired temperature is set too
high or too low.
The cooling or
heating capacity is not
adequate.
The heating and/or cooling load has
increased.
Cover large windows exposed to sunlight. Avoid using halogen
lamps or other high energy consumption devices.
Use the control panel on the unit.
The remote control does not work.
The remote control
does not work.
The remote control is not aimed at the
unit's remote control receiver.
The distance between the unit and the
remote control is too large.
The batteries are dead.
Make sure that the remote control is close enough to the unit
and is pointing towards the receiver.
Change batteries.
See next page.
An error code is displayed.
Check that the system main switch has not been tripped (if it
has, reset it). If the problem repeats immediately, contact Frico
Technical support and do not try to make the unit work.
Check there is power supply (by turning a light on, for
example).
