Frico PL1006 Скачать руководство пользователя страница 8

8

GB

Maintenance

Since fan motors and other components 
are maintenance free, no maintenance 
other than regular cleaning is necessary. 
The frequency of cleaning can vary 
depending on local conditions, but 
undertake cleaning at least twice a year. 
Inlet and exhaust grilles and impeller 
can be vacuum cleaned or wiped using a 
dry cloth. Use a brush when vacuuming 
to prevent damaging sensitive parts. 
Avoid the use of strong alkaline or 
acidic cleaning agents.

Overheating

The air curtain unit is equipped with an 
overheat protector. If this is deployed 
due to overheating, reset as follows:
1. Disconnect the electricity using the 

omnipolar switch.

2. Allow the electrical coil to cool.
3. Determine the cause of overheating 

and rectify the fault.

Once the power has been disconnected 
the unit can be started again.

Troubleshooting

If the fans are not blowing enough, 
check the following:
1. Operating power supply to the unit; 

check fuses, circuit-breaker, time 
switch that starts and stops the unit.

2. That the intake grille is not dirty.

If there is no heat, check the following: 

1. That the heat demand exists; 
check thermostat settings and actual 
temperature.

2. That the overheat protection for the 

motors has not been deployed

If the fault cannot be rectified, please 
contact a qualified service technician.

Residual current circuit breaker (E)

When the installation is protected
by means of a residual current
circuit breaker, which trips when

the appliance is connected, this may
be due to moisture in the heating
element. When an appliance containing
a heater element has not been used
for a long period or stored in a damp
environment, moisture can enter the
element.
This should not be seen as a fault, but
is simply rectified by connecting the
appliance to the mains supply via a
socket without a safety cut-out, so that
the moisture can be eliminated from
the element. The drying time can vary
from a few hours to a few days. As a
preventive measure, the unit should
occasionally be run for a short time
when it is not being used for extended
periods of time.

Safety

•  For all installations of electrically 

heated products should a residual 
current circuit breaker 300 mA for 
fire protection be used.

•  Keep the areas around the air intake 

and exhaust grilles free from possible 
obstructions!

•  During operation the surfaces of the 

unit are hot!

•  The unit must not be fully or partially 

covered with clothing, or similar 
materials, as overheating can result 
in a fire risk! 

•  This appliance can be used by 

children aged from 8 years and 
above and persons with reduced 
physical, sensory or mental 
capabilities or lack of experience 
and knowledge if they have been 
given supervision or instruction 
concerning use of the appliance 
in a safe way and understand 
the hazards involved. Children 
shall not play with the appliance. 
Cleaning and user maintenance shall 
not be made by children without 
supervision.

Содержание PL1006













Отзывы: