LAF 12
20
D. Timer setting
The -indicator will flash when the timer button is pressed, a beep will sound and
“00” will flash on the display. The timer setting will increase by one hour before the
appliance shuts down for each press of the timer button. When the number of hours
required is reached (e.g. 06), it takes 5 seconds for the timer setting to activate.
The -indicator and display will stop flashing.
The -indicator will be continuously lit. The display will show the actual humidity
level in the room and the appliance will run for six hours before shutting down.
To change the set time, press the timer button twice. “00” will appear on the display.
Press the timer button again until the time required is set.
To cancel a set time, e.g. to allow the appliance to run continuously, press the timer
button twice. “00” will appear in the display and the timer function will deactivate
after 5 seconds. The -indicator will go out and the actual humidity level will be
shown again.
The timer can be used for all modes of operation (dehumidifying, laundry drying and
air purification).
If the operation mode is changed, the timer will become inactive and will have to be
reset.
E. Emptying the water tank
Switch off the appliance when emptying the water tank.
Remove the tank (see fig. 3) and hold it carefully until it is empty.
Take care not to damage the float arm inside.
Figure 3
