Frico Elztrip EZ300 Series, Монтаж и эксплуатация, Страница: 9 / 12

Elztrip EZ300
15
GB
Maintenance
There might be a rattling noise the first time
of use when the surface coating of the panels
is settling.
If the heater is used in rooms where there
are aerosols, lacquer, solvents and similar,
this can cause a coating on the panels and
discolour them. The output is not affected.
In all electrical heating appliances, small
clicks can occur due to movement when the
material expands and contracts with changes
in temperature.
Residual current circuit breaker (E)
When the installation is protected by means
of a residual current circuit breaker, which
trips when the appliance is connected,
this may be due to moisture in the heating
element. When an appliance containing a
heater element has not been used for a long
period or stored in a damp environment,
moisture can enter the element.
This should not be seen as a fault, but is
simply rectified by connecting the appliance
to the mains supply via a socket without a
safety cut-out, so that the moisture can be
eliminated from the element. The drying
time can vary from a few hours to a few days.
As a preventive measure, the unit should
occasionally be run for a short time when it is
not being used for extended periods of time.
Safety
• For all installations of electrically heated
products should a residual current circuit
breaker 300 mA for fire protection be used.
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with flammable materials, as
covering can result in a risk of fire!
• This appliance is not intended for use
by children and persons with reduced
physical, sensory or mental capabilities,
or a lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by an individual responsible for
their safety. Children should be supervised
to ensure that they do not play with the
appliance.