Using The Fence In Straight Position
To learn more about Freud
®
products visit us at
www.freudtools.com
5
If you are using a bearing bit, align the fence flush with the bearing. If you are using a non-bearing bit, adjust the fence to
the desired profile.
B
Loosen the 4 screws that secure the fence faces. Move the fence faces as close together as possible without interfering with
the rotation of the bit. Tighten the screws. Keeping your hands away from the cutting edge of the bit, check to ensure that
the bit rotates freely and doesn’t contact any part of the router, router table, or fence.
C
Direction of feed when facing the fence is from right to left. If the chip guard was removed while making any adjustments,
be sure to properly install the chip guard before operating the table. Adjust the chip guard horizontally so that the entire bit
is covered and vertically so that it is as close to the material as possible without contacting the router bit or the material to
be routed.
D
CAUTION:
Turn off the router and disconnect from power before inserting the bit or making any adjustments. Consult the
router’s operator’s manual for instructions on installing a router bit.
Micrometer
Knobs
To use the fence in the straight position refer to the earlier section for instructions on how to align the infeed and outfeed
fences. Chip guard has been removed for clarity. Never operate the router without the guard properly positioned and
securely mounted.
Straight Fence Position
A
Loosen Screws
Loosen Screws
Tighten Screws
Tighten Screws
