Troubleshooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
Power Light off
Unit is not plugged in
No power at unit
Plug unit in
Push POWER button to turn
the power on
Check circuits, fuses, try a
different outlet
Power Auto
Shut off
Operation over time
Refill the water
Press the On/OFF Button
again to restart the unit.
Peculiar Odor
Unit is new
If unit is in use, the odor
may be a dirty water
reservoir, old tank water
or an old wick
Empty any water and clean
and refill tank
Replace wick
Excessive
Noise
Unit is not level
Low water level
Wick was not soaked
Place unit on a flat, even
surface
Check the water level.
Refill the reservoir if the
water is low.
Remove wick, soak for 2
minutes and replace wick
NOTE:
This device complies with Part 18 of the FCC Rules
Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
-- 7 --
-- 8 --
