Fresenius Medical Care 460018, Руководство оператора

Страница: 17 / 75

P/N 460018 Rev. D 11
S
ECTION
6: R
INSE
C
YCLE
1. Before initiating the RINSE CYCLE, the operator must ensure that the Dry Acid Dissolution Unit Access
Port Lid is in place (do not fully secure), and the Main Transfer Ball Valve is in the CLOSED position.
Make sure the input water source is in the ON position (Figure 1).
Figure 1
2. The RINSE CYCLE consists of two complete RINSE Operations. Press the Rinse side START button. The Fill
Indication Light will illuminate indicating the RINSE CYCLE has started and the Dry Acid Dissolution Unit
is in FILL Operation (Figure 2). Verify tank is filling and the water level stops at the 25-Gallon Sensor. Lift
the Access Lid and look into the tank to verify that the tank is filling.
Figure 2 Figure 3
3. Once the 25-Gallon Sensor is reached, the process automatically steps to
RECIRCULATE Operation (Figure 3). The pump and the mixer motor shall
run for a ten (10) minute period. With your safety glasses on, lift the lid
and ensure that the water is level with 25 Gallon Level Sensor. Since the
water shall be swirling in the tank it is okay for the level to be a little
above the 25 Gallon Sensor, but ensure that the water level is not rising.
During this time period, follow the procedure outlined on the following page to inspect the Spray Ball
for correct operation (Figure 4: Spray Ball Inspection/Cleaning Instructions).

CAUTION! B
EFORE INITIATING THE RINSE CYCLE
,
THE
D
RAIN
H
OSE MUST BE PLACED ABOVE A SUITABLE DRAIN
.
A
LWAYS LEAVE
A
CCESS
P
ORT
L
ID IN PLACE UNLESS MANUAL INSTRUCTS OTHERWISE
.

CAUTION!
IF A DRY ACID DISSOLUTION UNIT IS FOUND TO BE STANDING FOR
4
OR MORE HOURS WITH TREATED
WATER OR WETTED WITH TREATED WATER
,
THEN A DISINFECTION CYCLE
(
SEE SECTION
8.3
SODIUM HYPOCHLORITE
(
BLEACH
)
DISINFECTION
,
PAGE
23)
MUST BE COMPLETED BEFORE THE DISSOLUTION CYCLE IS STARTED
.
IMMEDIATELY AFTER COMPLETED RINSE CYCLE
,
MAKE A BATCH OF DRY ACID PRODUCT
.
DO NOT LEAVE THE DRY
ACID DISSOLUTION UNIT WITH ONLY TREATED WATER OR WETTED WITH ONLY TREATED WATER FOR
4
OR MORE
HOURS SINCE THE DRY ACID DISSOLUTION UNIT IS SUSCEPTIBLE TO BACTERIAL GROWTH
.
Place Main
Transfer Ball
Valve in the
closed position
by turning the
handle
clockwise until
it stops.
Access Port Lid
25-Gallon
Sensor
The Dry Acid
Dissolution Unit will
fill to the 25-Gallon
Sensor