Fresco Pro FFC1A-03H, Руководство пользователя

Страница: 64 / 83

Install Drain Pipe FCAC-KTSM-2008-12
62 The Installation of FFC1A
4. Install Drain Pipe
When connecting the pipe, please use the sealing material and pipe glove.
Caution:
z
The drain pipe of indoor unit must be heat insulated, or it will condense dew, as well as the connections
of the indoor unit.
z
Hard PVC binder must be used for pipe connection, and make sure there is no leakage.
z
With the connection part to the indoor unit, please note not to impose pressure on the side of indoor unit
pipes.
z
When the declivity of the drain pipe downwards is over 1/100, there should not be any winding.
z
The total length of the drain pipe when pulled out breadth wise shall not exceed 20m. When the pipe is
over long, a bracket must be installed to prevent winding.
z
Refer to the following figures to install the pipes.
Note
1. Injury means causing from the harm, burn and electrical shock, but not serious for the hospitalization.
2. The damage of material means the disrepair of property and material.
Upward drainage:
z
To make sure that the drainage pipe would not slant downward. Lead it upward to a height 750mm
maximum, then downward lead it.
z
When the drainage is upward, the upward drain pipe and elbow of the accessories must be adopted and
the height is less than 750mm, otherwise the drain pump water level switch malfunction will be caused.
z
After upward piping, the lead drain pipe must slant downward immediately. (Over 1/100)
As long as possible about(10cm)
Lean downward
over 1/100
Vp30
1.5m~2m
Lean downward over 1/100
Insulation material
Bend