Installation
Dimensions
6.1″
1.6″
6.4
″
4.1″
FAUCET
SUPPLY LINES
MALE SCREW
O-RING
RUBBER WASHER
BRASS WASHER
FEMALE SCREW
ALLEN
KEY
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
GRUB
SCREW
CAP
max1.1″
2
Unit:inches
1: Fit the O-ring in the underside of the
faucet
.
2: Screw the male screw and the
supply lines
into the
faucet
and fully hand tighten.
3: Pass the tail of
supply lines
through the hole on the basin from above, and place the
faucet
in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the rubber washer, the brass washer with the female screw from the underside of the counter.
5: Check that the faucet is correctly positioned, fully tighten the female screw.
6:
Connect the water supply pipes
to the tail of supply lines with the hot water and cold water.
This faucet meets or exceeds the following standards:
ASME A112.18.1/CSA B125.1/NSF61-9
This product has been tested and certified by IAPMO.
IAPMO LISTED
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
