Frequency Central System X CV Mixer, Создание документации

Страница: 3 / 3

Assemble in this order:

Resistors

22pF capacitors

IC socket

78L05 and 79L05 (don’t mix them up!)

Power header

Electrolytic capacitors
The pots and sockets need to be soldered to the ‘other side’ of the PCB, like this:

Insert all pots, make sure that they all sit flush with the PCB, put the panel over
them, turn the panel face down and solder the pots in place.

Insert the top 3 sockets (In 1, In 2, Norm), make sure that they all sit flush with the
PCB, put the panel over them, turn the panel face down and solder the pots in place.

Ground the sockets to the PCB using the ground pads, there’s one for each socket,
use a resistor leg to connect them. You’ll want to bend the socket ground tabs
towards the PCB by 45 degrees first, so they don’t foul on the next lot of sockets.

Insert the bottom 3 sockets (In 3, In 4, Inv), make sure that they all sit flush with the
PCB, put the panel over them, turn the panel face down and solder the pots in place.

Ground the sockets to the PCB using the ground pads, there’s one for each socket,
use a resistor leg to connect them. You’ll want to bend the socket ground tabs
towards the PCB by 45 degrees first, so they don’t protrude past the bottom of the
PCB.

Put the panel in place, tighten all nuts, add knobs.

Plug it in, test it, use it, love it.
RDH February 6
th
2016
http://www.frequencycentral.co.uk/