Frenzel Tube Amplifiers
www.frenzeltubeamps.com
© 2011 Copyright by Frenzel Tube Amplifiers. All rights reserved. All designs, technical data, pictures, and information are
copyrighted and may not be reproduced without the permission of Frenzel Tube Amplifiers.
Page 4
- POWER CORD
- FUSE
- BIAS SELECTOR SWITCH
- EFFECTS LOOP SEND LEVEL CONTROL
- EFFECTS LOOP SEND JACK
- EFFECTS LOOP RETURN JACK
- LINE OUT LEVEL CONTROL
- LINE OUT
- SPEAKER OUT JACK
- IMPEDANCE SELECTOR
PRICE: $1095.00
UPGRADE OPTIONS
:
1.
25 WATT VERSION -
The amp is also available with 25 watts output. No charge for this option.
2.
QUAD OF 6V6'S -
Four 6V6's in place of the pair of 6L6's for the smooth warm 6V6 tones. Includes 1/2 power switch
that turns of two of the 6V6's.Add $120.00
3.
WORLDWIDE POWER TRANSFORMER
- with 220V - 240V primaries. Add $55.00
4
.
EDGE FOOTSWITCH
- adds jack to rear panel for footswitch control on the NNFB EDGE switch. Includes classic
heavy duty footswitch with LED. Add $60.00
5. LONG TANK TUBE REVERB -
Pure tube driven vintage long tank reverb for those smooth warm jazz and blues tones.
Add $200.00
User’s Operation Guide:
FRONT PANEL CONTROLS:
NORMAL INPUT – input for NORMAL(Fender) preamp.
BRIGHT INPUT – input for BRIGHT(Marshal) preamp.
NORMAL GAIN – sets the volume and the point at which overdrive distortion is produced by the NORMAL
preamp. Set at ¼ for initial setting.
BRIGHT GAIN – sets the volume and the point at which overdrive distortion is produced by the BRIGHT preamp.
Set at ¼ for initial setting.
MASTER – sets the maximum volume of the amp and the point at which the output tubes saturate. The higher the
setting on the MASTER, the sooner the output tubes will saturate rate and produce output tube overdrive
distortion. Set at ½ for initial setting. Use the GAIN to adjust the volume level and preamp overdrive. As the GAIN
is increased the preamp will begin to produce preamp overdrive distortion. Turn the MASTER up for output tube
overdrive distortion. By adjusting the settings on the GAIN and MASTER you can set your desired amount
CLEAN and OVERDRIVE tones.
TONE STACK – is a three band Bass, Middle, and Treble tone filter. The controls are interactive in shaping the
tone. You will need to experiment to find the best setting for your playing requirements. Initial settings for all
three controls is the ½ position
BASS – attenuates the Bass frequencies from 10hz – 100hz as it is turned down.
MIDDLE – is a 500 hz notch filter that dampens the middle frequencies. As you turn the control down it deepens
the notch.
TREBLE – attenuates the high frequency tones from 1000hz - 15000hz. As it is turned down, the MIDDLE control
will have less effect.
