Frenzel Tube Amplifiers
www.frenzeltubeamps.com
2010 Copyright by Frenzel Tube Amplifiers. All rights reserved
.
All designs, technical data, pictures, and information are
copyrighted and may not be reproduced without the permission of Frenzel Tube Amplifiers.
Page 3
Unique NNFB "Edge" switch on the PRESENCE control that transforms the power amp section into a No-Negative-
FeedBack style amp for more open, less compressed tones.
Post output transformer LINE OUT with LINE OUT LEVEL control for recording or driving a power amp. Has an auto
switching internal load speaker simulator if speaker is not plugged into Speaker Out jack.
Class AB fixed biased matched pair of 6L6GC's in the output for fantastic headroom....and smooth blues saturation
sounds.
Custom output transformer for extended lows down to 20 hz. ...plus 4 - 8 - 16 ohm speaker outputs.
Laser Etched Faceplate
Chassis Dimensions: 12"W X 2"H X 8"D
Weight: 16 lbs.
Power Output : 40 watts
Dual Speaker Jacks
Speaker Impedance Selector 4 - 8 - 16 ohms
5U4 rectifier for optimum pick attack and sag...or you can use 5AR4, GZ34 or Solid State Plug-In for different amounts of
sag.
Primary Power Transformer Fuse
Extra long (10') three prong grounded power cord.
STANDBY switch to turn off the high voltage during warm-up. Rock solid point-to-point hand wiring using only the best of
parts...low noise tubular polypropylenes caps, metal film resistors, ceramic sockets, switchcraft jacks...etc.
Sweet vintage clean to classic overdrive tones with three different types of distortion depending on whether you are
overdriving the preamp, output... or both!
Tube compliment: 3 - 12AX7, 2 - 6L6GC, 1 - 5U4
FRONT PANEL:
- F INPUT
- M INPUT
- F GAIN WITH BRIGHT PULL SWITCH
- M GAIN WITH BRIGHT PULL SWITCH
- BASS WITH DEEP PULL SWITCH
- MIDDLE
- TREBLE
- MASTER
- PRESENCE with NNFB PULL SWITCH
- PILOT LIGHT
- POWER - STANDBY SWITCH
REAR PANEL:
- POWER CORD
- POWER PRIMARY FUSE
- LINE OUT LEVEL
- LINE OUT JACK
- SPEAKER OUT JACK
- SPEAKER IMPEDANCE SWITCH 4 - 8 - 16 OHM
