Frenzel Tube Amplifiers
www.frenzeltubeamps.com
© 2011 Copyright by Frenzel Tube Amplifiers. All rights reserved. All designs, technical data, pictures, and information are
copyrighted and may not be reproduced without the permission of Frenzel Tube Amplifiers.
Page 3
Classic 60's JTM45 - Bassman 5F6 style 3-BAND TONE STACK for extended flexibility in shaping your tone.
MASTER level control so you can crank the GAIN's up and overdrive the preamp without overdriving the output tubes.
Classic Type 5F6A Style Presence control .
Unique NNFB "Edge" switch on the PRESENCE control that transforms the power amp section into a No-Negative-
FeedBack style amp for more open, less compressed tones.
Classic 6L6's in the output in place of the original Deluxe 6V6's to give you more power and headroom. The bias is
optimized using FRENZEL Multi-Valve design which allows you to use octal based 6L6, 5881, KT66, KT88, 6550, or
EL34 tubes in the output stage without adjusting anything.
Preamp and driver tubes are 12AX7’s known for low noise and linearity. You may also use 12AT7's or 12AU7's for
different tones and overdrive.
Classic 60's style insertion type Serial Effects Loop with Return Jack (Power Amp In), Send Jack (Preamp Out), and
Send Level Control.
Post output transformer LINE OUT with LINE OUT LEVEL control for driving a higher power amp, or for using this amp as
a tube preamp/overdrive. Auto switching internal load if speaker is not connected to give you loaded output distortion.
NOTE: Also great for using headphones!
A classic heavy duty vintage output transformer for extended low frequency performance with 4 - 8 - 16 ohm outputs
selectable by a rotary switch.
EL34/6L6 BIAS SELECTOR SWITCH - Allows you to use either 6L6 or EL34 power output tubes
.
Power Output: 40 watts RMS (30 and 100 Watt version also available)
Power Selector Switch - provides three power levels. 1/4 - 1/2 - FULL power.
5AR4 rectifier, you can sub 5Y3, 5AR4, or Solid State Plug in for different amounts of sag.
IEC power socket with three prong grounded power cord.
STANDBY switch to turn off the plate voltage during warm-up.
Rock solid point-to-point hand wiring using only the best of parts...low noise tubular polypropylenes caps, metal film
resistors, ceramic sockets, switchcraft jacks...etc.
Sweet vintage clean to classic overdrive tones with three different types of distortion depending on whether you are
overdriving the preamp, output... or both!
Tube compliment: The amp comes with 3 - 12AX7, 2 - 6L6, 1 – 5AR4, but you can substitute 12AT7's or 12AU7's in the
preamp and driver for different tones and overdrive sounds. You can also substitute 5881's, KT66's, KT88's, 6550's, or
EL34's in the output stage for different sounds.
FRONT PANEL:
- NORMAL INPUT ( Type F INPUT)
- BRIGHT INPUT(Type M INPUT)
- NORMAL GAIN ( Type F GAIN)
- BRIGHT GAIN (Type M GAIN)
- BASS
- MIDDLE
- TREBLE
- MASTER
- PRESENCE with NNFB PULL SWITCH
-STANDBY SWITCH
- PILOT LIGHT
- POWER SWITCH
REAR PANEL:
- POWER CORD
- FUSE
- EL34/6L6 BIAS SWITCH
- EFFECTS LOOP SEND LEVEL CONTROL
- EFFECTS LOOP SEND JACK
