freightliner NEW CASCADIA 2016, Руководство пользователя

Страница: 59 / 207

radio operating instructions, see the radio manufac-
turer’s manual.
Climate Controls
NOTE: See Chapter 6 for detailed climate con-
trol panel operating instructions.
Cab Climate Control
The climate control panel allows you to control the
heating, ventilating, defrosting, and air conditioning
(A/C) functions. The cab climate control panel has
three switches to control the functions of the cab
temperature system; see
Fig. 4.34 :
•
fan switch with recirculation button
•
temperature control switch with A/C button
•
mode control switch (with bunk-override button
on sleeper cab only)
The fan switch controls the fan speed, and forces
fresh or recirculated air through the air outlets. To
increase airflow, turn the switch clockwise to a higher
number. To decrease airflow, turn the switch counter-
clockwise to a lower number.
Recirculation mode limits the amount of outside air
that enters the cab. Press the recirculation button to
prevent dusty or smoky air from entering the cab.
NOTE: To prevent the buildup of odors and/or
oxygen depletion inside the cab, the system
switches from full recirculation mode to partial
recirculation mode after 20 minutes.
The temperature control switch is used to select the
desired temperature. Turn the switch clockwise to the
red area for warm air. Turn the switch counterclock-
wise to the blue area for cool air.
The A/C cools and dehumidifies the air inside the
cab. Press the A/C button, located in the center of
the temperature control switch, to turn the A/C on
and off.
The mode control switch allows the control of air flow
through the face outlets, the floor outlets, the defrost
(windshield) outlets, or a combination of these out-
lets. See
Fig. 4.35 .
Bunk-Override Button
The bunk-override button is located in the center of
the cab air-selection switch (sleeper-cabs only). See
Fig. 4.35 .
Press the bunk-override button to make the cab con-
trols override the settings on the sleeper temperature
control panel; the sleeper temperature will mimic the
cab settings. An amber LED in the button is illumi-
nated when the bunk-override mode is activated.
When the override switch is not activated, the cab
climate control panel can be adjusted without affect-
ing the sleeper settings.
09/09/2016 f611324
1 2 3
1. Fan Switch
2. Temperature Control Switch
3. Mode Control Switch
Fig. 4.34, Cab Climate Controls
01/15/2016 f611327
1
2
3
4
5
6
7
NOTE: There are intermediate modes between each
switch position.
1.
Face Mode
2. Bi-Level Mode
3. Floor Mode
4. Floor/Defrost Mode
5. Defrost Mode
6. All Mode
7. Bunk Override Button (on sleeper-cabs only)
Fig. 4.35, Mode Control Switch With Bunk Override
Button
Driver Controls
4.19