![freightliner BUSINESS CLASS M2 Скачать руководство пользователя страница 24](http://html1.mh-extra.com/html/freightliner/business-class-m2/business-class-m2_driver-manual_2331361024.webp)
Rotating the control dial forward (in a counterclock-
wise direction) turns the wipers on. If they are al-
ready on, rotating the handle further forward (to a
faster speed setting) increases the speed of the wip-
ers through the various delay settings, and to LO and
then HI.
Rotating the control dial in the opposite direction
(clockwise) causes the wipers to slow down. Rotating
the control dial clockwise as far as it will go (to the
OFF setting) turns the wipers off.
The washers are operated by a yellow button at the
very end of the turn signal lever. To operate the
washers, press the button in and hold it in until you
want the washers to stop.
Headlight High Beams
Push the turn signal lever forward, towards the wind-
shield, to turn on the high-beam headlights. Pull the
turn signal lever back to its original position to turn
them off. See
When the high beam headlights are on, a blue light
illuminates on the instrument cluster between the ta-
chometer and speedometer. For vehicles built to op-
erate in the United States, switching on the high
beams will switch off the road lights.
NOTE: The ignition switch must be on for the
high beams to work.
With the headlight low beams on, pull the lever back-
ward, towards the steering wheel, to flash the high
beams (turn them on momentarily).
The headlight low beams remain on continuously
during high beam operation. If the low beam head-
lights are turned off by use of the headlight switch,
the high beams turn off also.
Hazard Warning Flasher
The hazard warning light flasher (
) is a red
rocker switch located on the top of the multifunction
switch module. When the flashers are activated, all
of the turn signal lights (front, side, and rear) and the
two green indicator arrows on the control panel will
blink on and off.
To flash the hazard warning lights, press down on
the upper part of the rocker (towards the dash). To
stop the hazard warning lights, press down on the
lower part of the rocker (towards the steering wheel).
Horn Controls
NOTE: It is possible to have both the electric
and the air horn installed on one vehicle.
Electric Horn
A single electric horn is standard. Dual electric horns
are available as an option.
f820383
1
3
2
4
5
10/29/2001
Rotate the control dial away from you to turn the wipers
on, or speed them up.
Rotate the control dial towards you to slow the wipers
down, or turn them off.
1.
Washer Button
2.
OFF Position
3.
Delay Positions
4.
Wipers On, Low Speed
5.
Wipers On, High Speed
Fig. 4.12, Wiper/Washer Controls
10/17/2001
f820385
1
2
Move the lever away from you to turn on the high beams.
Move the lever back to its original position to turn them
off.
Move the lever towards you to flash the high beams
momentarily.
1.
Turn Signal Lever
2.
Boot
Fig. 4.13, Headlight High Beams
Controls
4.6