freightliner 108SD 2021, Руководство пользователя

Страница: 74 / 191

NOTE: Do not use a lube plate (high density
polyethylene) on top of the fifth wheel or on the
kingpin instead of grease without prior approval
by Fontaine Fifth Wheel. The additional thick-
ness of this material can prevent the proper op-
eration of the fifth wheel and may cause a dan-
gerous condition.
NOTE: Fontaine suggests the use of a Moly
based lubricant such as Mobilgrease XHP 320
or equivalent when applying lubricant to the
locking jaw and wedge.
3. Lubricate the fifth wheel prior to opening and
closing it. Separate the jaw and wedge with a
screwdriver, and grease the full length of their
mating surfaces. Lubricate the top and bottom
contact surfaces of the jaw and wedge. See
Fig. 5 . Open and close the fifth wheel several
times to further distribute the grease.
Lightly oil other moving parts in the fifth wheel.
4. Apply grease to the top plate. Spread grease all
over the mating surface of the top plate. Be sure
the grease pockets built into the top plates are
full of grease.
Holland FWS1
Apply a heavy coat of grease to the top plate, either
through the grease fittings located on the underside
of the top plate, or by direct application.
Holland FW35
1. Using a water-resistant lithium-base grease,
grease the top plate.
2. Using a light oil (such as SAE 10W or 20W
motor oil), lubricate the cam track and pivot. See
Fig. 8 .
3. Grease the yoke tips, locks, and the release
handle and spring; see
Fig. 9 . Grease the
mounting bracket supports through the grease
fittings. A “low temp” grade grease rated for
-30°F (-34°C) or lower such as Cato Oil and
Grease #5213, Craftsman Chemical Co. #LTF 2,
Mystic LP-200, or equivalent is recommended.
Jost
Lubricate the kingpin lock using a hand pump grease
gun through the grease zerk on the skirt of the fifth
12/03/2010 f311136
1
Use a light oil (such as SAE 10W or 20W motor oil) to
lubricate the cam track and pivot.
1. Cam Plate
Fig. 8, Holland FW35 Fifth Wheel, Oil Lubrication
12/03/2010 f311135
1
2
2
3
3
4
1. Release Handle and
Spring
2. Grease Fitting
3. Yoke Tip
4. Locks
Fig. 9, Holland FW35 Fifth Wheel, Grease Lubrication
Frame and Frame Components
31
108SD and 114SD Maintenance Manual, May 2018
31/7