3
PNP lnstall instructions
Use glue to install the front/rear fuselage.
A-
B-
Carbon tube
(
Ø6
x
200mmmm)
Carbon square tube
(
8.5x8.5x800mm)
A
B
Step
4
Step
3
Battery compartment
Elevator/rudder servo cable
Traction steel wire
Step
1
A
B
C
D
As the photo shown:
1
.
Install the vertical stabilizer on the horizontal stabilizer and use
2pcs screws to fix the left/right vertical stabilizer.
。
2.When install the vertical stabilizer, pull out the rudder servo
cable through the inside trough
。
3
.
Use the traction metal wire to pull the elevator/rudder servo cable
to the battery compartment.
4
.
Install the horizontal stabilizer on
the rear of fuselage and use 4pcs
screws to fix it.
A- Screw
(PA3x8 4pcs)
B- Vertical tail
C-
Horizontal tail
D- Servos
wire
E- Screw
(PA3x8 4pcs)
E
Step
2
Traction steel wire use instruction
Through investigation, excessive servo extension line will increase the risk of poor contact joints, and lead to the
servo outages caused flight accidents. Because of A-10 large and flat trough interior space, we don't use the
servo extension wire in this jet. As the below photo shown, package includes a traction steel wire, we can use it to
pull the main wing/elevator/rudder servo cables to the battery compartment.
Install fuselage
A-10 Thunderbolt II
Item No.:FJ311
Install Horizontal stabilizer / Vertical stabilizer
