Model No:-
5B5-
50.0
34.0
15.6
15°
15°
25.8
Pick Guard Thickness assumed to be 2.3mm
Mounting Holes should be Ø3.5 Csk (to suit M3 x 10mm Csk Screws provided)
Mounting Hole Ctrs are tolerant to a range between 41.0 and 41.4mm
Minimum Lever Slot Dimensions to Pickguard: 28.0 x 2.0mm
A small chamfer may be added to the external edges of a narrower Lever slot to adapt it.
This guide requires and assumes proper competencies with regard to electrical and practical work,
safety and the correct use of any equipment referenced here. Always take precautions to protect
the guitar, yourself and others. Ensure that any accociated products are installed in full accordance
with the manufacturers instructions.
Check that the Free-Way Blade Switch will fit - refer to dimensional information provided
Use 22 AWG Wire, strip insulation back 5mm, twist strands and locate into terminal holes.
Make any 'daisy-chain' links and locate these into one of the terminal hole pairs.
Solder using multi-core solder. Ensure solder joint is clean and flows about terminal pad.
Avoid excessive solder, avoid contacting any other part of the switch with the soldering iron.
The switch metalwork is stainless steel and can not be soldered, nor should this be attempted.
15°
15°
41.2 Ctrs
2.0
7.0
Notes:-
Avoid using mounting screws which are any longer than the ones supplied
Switch Tip to suit 3.5mm x 1.0mm (0.138" x 0.039") lever stem.
General Installation Instructions
28.0
50.0
Lever Slot & Mounting Hole Dimensions
20°
Cavity Depth 34mm Min.
5B5 General Installation : Last Updated Jul 2018
© Free-Way 2018
