background image

  

b. Hold the unit in a vertical position with the Mic (Microphone) 5cm away from the mouth. While holding the PTT button,  

speak into the microphone in a normal tone of voice.  

c. Release the PTT button when you have finished transmitting.For others to receive your transmission, they must be on the same 

channel as you. 

Reset the unit 

Take away the battery from walkie talkie battery compartment,then hold the Menu/PWR button meanwhile put back the battery   

to walkie talkie battery compartment in right polarity,the unit will turn on and display CH 100 ,at this time ,release the PTT button. 

Channel and Frequency (MHz)  

 

 
 

TROUBLE SHOOTING GUIDE 
PROBLEM   

GUIDE   

No power or radio switchs off after short time 

1:Check charger and correct battery installation.                                                                         
2:Clean battery contacts(Important!) .                                                                               
3:Replace battery by fully charged or a new battery .                                                           
4:Battery capacity poor:battery defective or at end of 
lifetime replace battery. 

I cannot communicate with other group members   

1:Verify,that the channel frequency and the CTCSS 
are the same in the whole group.If you use factory 
default programming ,this is automatically ok if all 
members of your group use the same channel 
number.                                                                                                                                                             
2:The other group members are not with the radio 
coverage.   

You can hear the voice from other users,but they 
cannot hear you   

1:Please change your setting to exactly the same 
number as the partners are using . 

Others hear my voice with interruptions only   

1:Too weak signal-too far away .                                                                                               
2:External mic defective? Please let service technicial 
check. 

I hear too many stations from outside my group 

1:Another group is using the same channel number 
-change channel         

 

 

 

 

 
Caution: 
Battery 

1:If you use Alkaline battery ,please use AAA size battery ,but dont attempt to charge alkaline batteries. 
2:Please dont mix old and new batteries ,it will affect the battery lifetime . 
3:Do not mix alkaline,standard (carbon-zinc),or rechargeable(Ni-Cd,Ni-MH,etc.)batteries. 
4:Alkaline battery have expiry time ,please make sure the battery are valid. 
 

Ch.          Frequency 

Ch.        Frequency 

Ch.        Frequency 

Ch.        Frequency 

1              462.5625 
2              462.5875 
3              462.6125 
4              462.6375 
5              462.6625 
6              462.6875 

7            462.7125 
8            467.5625 
9            467.5875 
10          467.6125 
11          467.6375 
12          467.6625 

13        467.6875 
14        467.7125 
15        462.5500 
16        462.5750 
17        462.6000 
18        462.6250 

19          462.6500 
20          462.6750 
21          462.7000 
22          462.7250 

Содержание RD866








Отзывы: