TOWER SYSTEM
Powering the
TWR-RF-SNAP
Attach the included microUSB cable
to the USB interface on the TWR-RF-
SNAP Tower System module. Insert the
opposite end of the microUSB cable in
either a USB port or USB wall adapter.
Slide the power switch to the right
(towards the microUSB receptacle). A
small green LED (D5), located next to the
USB port, should illuminate indicating
that the Tower System module is
correctly powered. With the power
switch in the far-right position, the
TWR-RF-SNAP can also be powered
by inserting the module into the Tower
System and providing power via the
TWR-ELEV or MCU module. Optionally,
with the power switch in the far-left
position, the TWR-RF-SNAP can be
powered via the battery connector in a
stand-alone configuration only.
Using the Default
Application
The TWR-RF-SNAP Tower System
module comes pre-loaded with a
simple application to demonstrate user
interaction with the module. Once power
is supplied to the Tower System module,
the program will blink the red LED.
The green LED has been configured to
react to user input. Use the push-button
labeled “Switch 2” to turn the green
LED on and “Switch 3” to turn the green
LED off.
Step-by-Step Installation Instructions
STEP
1
STEP
2
