Freescale Semiconductor NXP CodeWarrior USB TAP, Руководство пользователя, Страница: 15 / 54

15 USB TAP Users Guide
3
Using the USB TAP
This chapter provides system startup procedures, explains how the USB TAP works and
provides important information about using the system.
The sections are:
• USB TAP System Startup
• Notes on Using the USB TAP
USB TAP System Startup
This section explains how to start using the USB TAP and the debugger.
Before starting up the USB TAP, make sure you have:
• Connected the USB TAP to your Host Computer with your USB 2.0 Cable
• Connected the USB TAP to the target system (see “Connecting to the Target and
your Host Computer” on page 11 )
• Installed the USB TAP drivers
• Installed the debugger software and properly configured it to communicate with the
USB TAP.
To start up the USB TAP:
1. Apply power to your target system.
2. Start the debugger.
You are now ready to begin your debug session. For information on using the debugger,
refer to the
IDE User Guide and the targeting manual.
Notes on Using the USB TAP
This section provides information specific to the USB TAP. This section is useful for
users who are not familiar with USB TAP operation. Also refer to the debugger
documentation for becoming familiar with the system operation.
These topics provide information specific to USB TAP operation:
• Run/Pause/Mixed Mode States
• Breakpoints in Exception/Interrupt Handlers
U SB_TA P.book Page 15 Thursday, N ovem ber 10, 2005 2:27 PM