M 6 8 E V B 9 1 2 C 3 2
0 5 / 1 5 / 0 3
3
Cautionary Notes
1) Electrostatic Discharge (ESD) prevention measures should be applied whenever handling
this product. ESD damage is not a warranty repair item.
2) Axiom Manufacturing does not assume any liability arising out of the application or use of
any product or circuit described herein; neither does it convey any license under patent
rights or the rights of others.
3) EMC Information on the M68EVB912C32 board:
a) This product as shipped from the factory with associated power supplies and cables, has
been tested to meet with requirements of CE and the FCC as a
CLASS A
product.
b) This product is designed and intended for use as a development platform for hardware
or software in an educational or professional laboratory.
c) In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate prevention measures.
d) Attaching additional wiring to this product or modifying the products operation from the
factory default as shipped may effect its performance and also cause interference with
other apparatus in the immediate vicinity. If such interference is detected, suitable
mitigating measures should be taken.
Terminology
This development board applies option selection jumpers. Terminology for application of the
option jumpers is as follows:
Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and the
shunt is installed so that the 2 pins are connected with the shunt.
Jumper off, out, or idle = jumper or shunt is installed so that only 1 pin holds the shunt,
no 2 pins are connected, or jumper is removed. It is recommended that the jumpers be
idled by installing on 1 pin so they will not be lost.
This development board applies hardwired option selections for several option jumper
selections. This option selection applies a circuit trace between the option pads to complete a
default connection. This type connection places an equivalent Jumper Installed type option.
The circuit trace between the option pads may be cut with a razor blade or similar type knife to
isolate the default connection provided. Applying the default connection again can be
performed by installing the option post pins and shunt jumper, or by applying a wire between
the option pads.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..
